Sex Machine Enhot Maintenance, Service and Troubleshooting
Maintenance and service Enhot Sex machine
Weak battery in the driver and battery replacement
The controller responds to the press, but does not start the machine.
Replace the LR23 battery. Loosen the screw on the driver lid and pry the lid apart using the nail or screwdriver gap at the bottom.
Stuck machine – clean the guide rods. Must be done as needed – at least once a year
The machine may start or stutter at low speed. As a rule, it occurs after 6-12 months when exposed to dust and minor dirt. The machine will only start temporarily or only when pushed by hand.
See pictures for pictorial instructions.
Prepare an Allen or Allen screwdriver 2 and 2,5 and 4,5mm.
Loosen the 2 large screws on the bar on the side of the machine by hand and remove the bar (Figure 1).
Loosen the 2 bolts holding the connecting rod (both bolts right next to each other) and remove the connecting rod using a 2mm and 4.5mm Allen screw. Loosen to the left (i.e. counterclockwise).
Loosen the 8 screws of the steel lid of the machine with a 2.5mm Allen key and remove the lid.
Clean both rods inside the machine (guide bearing) from dirt (sticky oil due to dirt - clogged with dust, hair or other dirt). Apply a thin layer of oil to the guide bearing rods (using a squeegee or small brush).
Put the machine back together.
The frequency of maintenance depends on the cleanliness of the environment and exposure to dust. When the machine is not in use, we recommend cleaning the machine or covering the holes inside the machine with a cloth.
This service can be done for you by our sex shop for 1000czk / 40 Eur + shipping (movement parts) there and back
Motionless machine
The machine doesn't respond to the controller at all, even if you help it with your hand. Send in a warranty claim.
Post-warranty claims will usually be settled by replacing the unit for 3/4 the price of a new machine.
